Hello all,
Long story short, existing production virtual chassis mixed with EX4500 and EX4200 devices. Discovered VC cables are not wired correctly and an EX4500 is set to master with an EX4200 set to backup. We want to get the wiring correct in addition to making the setup NSSU compatible. I know the commands to move member IDs but this requires us to swap an EX4200 (node 1) with an EX4500 (node 2). My question is what is going to happen when I move these around? Will changing the member IDs also correct the programming so anything that was 1/0/* will change to 2/0/* and vice versa? If not will I have to just manually make the changes and make sure I map the ports correctly and change any other relevant programming?
Attached picture is the current wiring and how it is supposed to be after the change. Thanks and let me know if you would need more information.