Hi Community,
This might sound easy for all of you but I've set my first virtual switch with a couple of EX4550s.
The Virtual-switch is Up and running. I tested it and is working perfectly. However. I cant see to understand how to read the interfaces.
This is the config
Virtual Chassis Mode: Mixed
Mstr Mixed Route Neighbor List
Member ID Status Serial No Model prio Role Mode Mode ID Interface
0 (FPC 0) Prsnt XXXXXXXXXX ex4550-32f 255 Master* Y VC 1 vcp-255/0/0
1 (FPC 1) PrsntXXXXXXXXXX ex4550-32f 255 Backup Y VC 0 vcp-255/0/0
If I run a "-show interface terse" command I only get these interfaces
vcp-255/0/0 up up
vcp-255/0/0.32768 up up
xe-0/0/1 up up
xe-0/0/1.0 up up eth-switch
xe-0/0/4 up down
xe-0/0/4.0 up down eth-switch
xe-0/0/5 up down
xe-0/0/5.0 up down eth-switch
xe-1/0/1 up up
Any way if I did set something wrong?
If I run a " show interface | display set" from the config mode It lists all the interfaces but I dont know how to tell which interfaces are from which Switch.
Thanks for the help.