I'm trying to use both 10gig LR and SR SFPs in the same aggregated interface (ae) on a EX4500 virtual chassis, and it's not working. I'm getting these messages in the messages log:
Mar 8 11:06:48 4500vca chassism[1305]: cm_vchassis_extended_vcport_validate_remove Port xe-0/0/33 validate FAILED 4
Mar 8 11:06:55 4500vca chassism[1305]: validate_configuration (625) config validation failed pic 0xf05a port 33 xcvr_type 8 AN 1 speed 3 duplex 0
These are Juniper branded SFPs according to show chassis hardware:
FPC 0 REV 16 750-038519 XXXXXXXXXXX EX4500-40F
Xcvr 33 REV 01 740-021309 58T027401729 SFP+-10G-LR
FPC 1 REV 16 750-038519 XXXXXXXXXXX EX4500-40F
Xcvr 33 REV 01 740-037004 ARE274T SFP+-10G-SR
The single mode interface doesn't even show up in show interfaces terse:
4500vca>show interfaces terse | match 33
vcp-255/0/33 up up
vcp-255/0/33.32768 up up
xe-1/0/33 up up
xe-1/0/33.0 up up aenet --> ae25.0
I have this same problem with another ae using xe-0/0/5 and 1/0/5. The xe-0/0/5 interface doesn't even show up.
The device on the "other side" of this ae is an mx960 router and it has no problem with using SR and LR in the same ae.
What happened?