This is what I want to know if you did? Adding the static mac address is adding it to the ethernet switching table, but to limit mac it needs secure-access port which is not available. So when these steps are followed, I would like to what additional heirarchy is now visible.
1. Select Configure>Security>Port Security.<=======???????? Need to see what else has changed
2. Select one or more interfaces from the Interface List.
3. Click the Edit button. If a message appears asking whether you want to enable port security, click Yes.
...
To add allowed MAC addresses:
1. Click Add.
2. Type the allowed MAC address and click OK.
Repeat this step to add more allowed MAC addresses.
6. Click OK when you have finished setting MAC limits.
7. Click OK after the configuration has been successfully delivered
When you enable this feature, you would just need to clear the ethernet switching table of the mac addresses on the defined port. Any mac addreses learned will not be affected until they are flushed out of the ethernet switching table.
Also all you have to do is to change the MAC address of your test device (google it
) to one that is not yet learned and try connecting on the port where security has been enabled.