I too have an error like the below , but my setup is up and running for more than 2 months.
2 alarms currently active
Alarm time Class Description
2015-11-26 19:22:54 IST Minor FPC 1 PEM 0 is not powered
2015-11-26 19:02:54 IST Minor FPC 0 PEM 0 is not powered
I do not have alram on 4300, I have two 4600 + 2 4300 in VC.
eg:
request virtual-chassis mode mixed reboot
set virtual-chassis preprovisioned
set virtual-chassis member 0 role routing-engine
set virtual-chassis member 0 serial-number x.x.x.x
set virtual-chassis member 1 role routing-engine
set virtual-chassis member 1 serial-number x.x.x.x
set virtual-chassis member 2 role line-card
set virtual-chassis member 2 serial-number x.x.x.x
set virtual-chassis member 3 role line-card
set virtual-chassis member 3 serial-number x.x.x.x
- On each individual member switch, configure the ports that will be used to interconnect the member switches into VCPs using the following command:
user@switch> request virtual-chassis vc-port set pic-slot pic-slot-numberport port-number localwhere pic-slot-number is the PIC slot number.
For instance, if you wanted to set port 0 on the QSFP+ interface on PIC slot 2 as a VCP:
user@switch> request virtual-chassis vc-port set pic-slot 2 port 0 localThe VCPs automatically bundle into a Link Aggregation Group when two or more interfaces of the same speed are configured into VCPs between the same two member switches. See Understanding EX Series Virtual Chassis Port Link Aggregation.
Have you done a preprovisioned setup , there was a mistake in the juniper document where they did not add "local "to the configuration which was fixed by Juniper after I reported that to them.I think if you follow that steps of preprovisioned it should work.
For connection , please refer the below