Hi everybody.
Let say we have two switches SW1,SW2 which do not have dediacted VCP port, we therefore decided to use UPLINK port as VPC port.
Both switches have factory default config. Before we can connect them via VCP ports we must configure uplink port as VCP port.
We start with SW1:
SW1:
SW1> request virtual-chassis vc-port set pic-slot 1
Above I did not specify any member id as we do not have one( remember this SW has factory defaults). So what value is assumed above?
SW2:
SW2>request virtual-chassis vc-port set pic-slot 1
Above I did not specify any member id as we do not have one( remember this SW has factory defaults). So what value is assumed above?
Thanks and have a nice weekend!!