Hello.
Company has an headquarter and several remore branch offices. Provider provides L2 VPN from the HQ to the each branch office. To the HQ packets comes into the VLANs. One branch - 1 VLAN.
At the HQ there are 1 cable from the provider and it's connected to Juniper EX2200 JunOS 11.4R1.6 at port ge-0/0/23. Port ge-0/0/4 is connected to the LAN of the HQ.
IP addressing is the same at the HQ and branches.
The goal is to give an access to the local resources of the HQ to a branch and vice versa.
On the Juniper there are created VLANs with provider's IDs 1800-1807. They are named. Port ge-0/0/23 is setted as trunk and is a member of all VLANs.
Problem is, I can assign to ge-0/0/4 only 1 VLAN. And there will be a connection to only 1 branch. But if I make another access port with another VLAN ID and connect it to the HQ LAN, then only one of them will be working. And I can't switch ge-0/0/4 to trunk because it's goes to the simple switch.
With this Juniper, how can I make the HQ to see all of the branches? And I need to the IP addressing stays the same.