Hi all,
Trying to set up an aggregated interface using port 22 on each switch in a 2-switch VChassis. Before I tried setting up the ae interface, both links were up, and the interfaces were in regular L2 access mode. Upon setting up the ae0 interface and adding the ge-[#]/0/22 interfaces to it, I'm seeing that the links (L1) are now down between the switches (the second switch being a Cisco 3550.)
Do I have to do something further to bring the links up on the Juniper side?
Some possibly helpful data below:
admin@lab-ex2200-stack> show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis CW021309xxxx Virtual Chassis
Routing Engine 0 REV 22 750-026468 CW021309xxxx EX2200-24T-4G
Routing Engine 1 REV 24 750-026468 CW021332xxxx EX2200-24T-4G
FPC 0 REV 22 750-026468 CW021309xxxx EX2200-24T-4G
CPU BUILTIN BUILTIN FPC CPU
PIC 0 BUILTIN BUILTIN 24x 10/100/1000 Base-T
PIC 1 REV 22 750-026468 CW021309xxxx 4x GE SFP
Xcvr 2 NON-JNPR P680T5L SFP-SX
Xcvr 3 a< NON-JNPR 01120348 SFP-SX
Power Supply 0 PS 100W AC
Fan Tray Fan Tray
FPC 1 REV 24 750-026468 CW021332xxxx EX2200-24T-4G
CPU BUILTIN BUILTIN FPC CPU
PIC 0 BUILTIN BUILTIN 24x 10/100/1000 Base-T
PIC 1 REV 24 750-026468 CW021332xxxx 4x GE SFP
Xcvr 2 NON-JNPR P6A1MNY SFP-SX
Xcvr 3 NON-JNPR P681NF2 SFP-SX
Power Supply 0 PS 100W AC
Fan Tray Fan Tray
admin@lab-ex2200-stack> show configuration interfaces ge-0/0/22
ether-options {
802.3ad ae0;
}
{master:0}
admin@lab-ex2200-stack> show configuration interfaces ge-1/0/22
ether-options {
802.3ad ae0;
}
{master:0}
admin@lab-ex2200-stack> show configuration interfaces ae0
aggregated-ether-options {
lacp {
active;
}
}
unit 0 {
family ethernet-switching {
port-mode access;
vlan {
members 3;
}
}
}
admin@lab-ex2200-stack> show interfaces ae0 extensive
Physical interface: ae0, Enabled, Physical link is Down
Interface index: 128, SNMP ifIndex: 551, Generation: 131
Link-level type: Ethernet, MTU: 1514, Speed: Unspecified, BPDU Error: None,
MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: Disabled,
Flow control: Disabled, Minimum links needed: 1, Minimum bandwidth needed: 0
Device flags : Present Running
Interface flags: Hardware-Down SNMP-Traps Internal: 0x4000
Current address: 54:e0:32:9a:04:c3, Hardware address: 54:e0:32:9a:04:c3
Last flapped : 2016-12-15 17:23:26 UTC (00:51:56 ago)
Statistics last cleared: Never
Traffic statistics:
Input bytes : 0 0 bps
Output bytes : 0 0 bps
Input packets: 0 0 pps
Output packets: 0 0 pps
IPv6 transit statistics:
Input bytes : 0
Output bytes : 0
Input packets: 0
Output packets: 0
Input errors:
Errors: 0, Drops: 0, Framing errors: 0, Runts: 0, Giants: 0,
Policed discards: 0, Resource errors: 0
Output errors:
Carrier transitions: 0, Errors: 0, Drops: 0, MTU errors: 0,
Resource errors: 0
Logical interface ae0.0 (Index 65) (SNMP ifIndex 607) (Generation 130)
Flags: Hardware-Down Device-Down SNMP-Traps 0x4000 Encapsulation: ENET2
Statistics Packets pps Bytes bps
Bundle:
Input : 0 0 0 0
Output: 0 0 0 0
Adaptive Statistics:
Adaptive Adjusts: 0
Adaptive Scans : 0
Adaptive Updates: 0
Link:
ge-0/0/22.0 <-- down
ge-1/0/22.0 <-- down
LACP info: Role System System Port Port Port
priority identifier priority number key
ge-0/0/22.0 Actor 127 54:e0:32:9a:04:c0 127 1 1
ge-0/0/22.0 Partner 1 00:00:00:00:00:00 1 1 1
ge-1/0/22.0 Actor 127 54:e0:32:9a:04:c0 127 3 1
ge-1/0/22.0 Partner 1 00:00:00:00:00:00 1 3 1
LACP Statistics: LACP Rx LACP Tx Unknown Rx Illegal Rx
ge-0/0/22.0 0 0 0 0
ge-1/0/22.0 0 0 0 0
Marker Statistics: Marker Rx Resp Tx Unknown Rx Illegal Rx
ge-0/0/22.0 0 0 0 0
ge-1/0/22.0 0 0 0 0
Protocol eth-switch, Generation: 148, Route table: 0
Flags: Is-Primary
-=-=-=-=-
SW4-3550#show etherch summ
Flags: D - down P - bundled in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
M - not in use, minimum links not met
u - unsuitable for bundling
w - waiting to be aggregated
d - default port
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----------+-----------------------------------------------
1 Po1(SD) LACP Fa0/11(D) Fa0/12(D)
SW4-3550#sh runn int Fa0/11
Building configuration...
Current configuration : 113 bytes
!
interface FastEthernet0/11
switchport access vlan 3
switchport mode access
channel-group 1 mode active
end
SW4-3550#sh runn int Fa0/12
Building configuration...
Current configuration : 113 bytes
!
interface FastEthernet0/12
switchport access vlan 3
switchport mode access
channel-group 1 mode active
end
SW4-3550#sh runn int Po1
Building configuration...
Current configuration : 81 bytes
!
interface Port-channel1
switchport access vlan 3
switchport mode access
end