Hello, I am trying to bring up a combo 1/10G Intel transceiver (AFBR-709DMZ-IN2) on our EX2200 switch. Transceiver works well at Gigabit speed with other vendors switches, but here JunOS even does not shows fiber interfaces:
> show interfaces ge-0/1/0
error: device ge-0/1/0 not found
{master:0}
During last two days I've searched across all forums and tried all possible solutions - no effect. JunOS update to 12.3 and 15.1 gives no effect too.
Could you please advise me if it is possible at all to bring it up here?
Here comes some diagnostics information:
/var/log/messages: Mar 2 15:01:09 chassism[1201]: XCVR: Unit 0, SFP+ Optic of type 1 inserted in SFP Cage!!
> show chassis pic pic-slot 1 fpc-slot 0
FPC slot 0, PIC slot 1 information:
Type 4x GE SFP Builtin
State Online
Uptime 20 minutes, 9 seconds
PIC port information:
Fiber Xcvr vendor Wave- Xcvr
Port Cable type type Xcvr vendor part number length Firmware
0 10GBASE SR MM Intel Corp AFBR-709DMZ-IN2 850 nm 0.0
{master:0}
> show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis CW0212507548 EX2200-24T-4G
Routing Engine 0 REV 22 750-026468 CW0212507548 EX2200-24T-4G
FPC 0 REV 22 750-026468 CW0212507548 EX2200-24T-4G
CPU BUILTIN BUILTIN FPC CPU
PIC 0 BUILTIN BUILTIN 24x 10/100/1000 Base-T
PIC 1 REV 22 750-026468 CW0212507548 4x GE SFP
Xcvr 0 NON-SFP AA17133027P SFP+-10G-SR
Power Supply 0 PS 100W AC
Fan Tray Fan Tray
{master:0}
> show virtual-chassis
Virtual Chassis ID: 06d5.9776.851b
Virtual Chassis Mode: Enabled
Mstr Mixed Route Neighbor List
Member ID Status Serial No Model prio Role Mode Mode ID Interface
0 (FPC 0) Prsnt CW0212507548 ex2200-24t-4g 128 Master* NA VC
Member ID for next new member: 1 (FPC 1)
{master:0}
> show virtual-chassis vc-port
fpc0:
--------------------------------------------------------------------------
{master:0}