Hello
I have a situation. On our floor I have 1 SRX220. It connects to a Cisco 3560 switch with mm fiber. From the Cisco siwtch it has to convert it to a single mode fiber to an EX2200 switch that is at another building. I allowed all vlans in a trunk mode to go accross to the SRX and I can not get a SHCP on the LAN side. I get a 169 IP. On the SRX and EX2200 both are in trunk mode and all vlans are going accross. Now the one off is that the Cisco switch is in the middle because it has to go from mm fiber where the SRX sits to a single mode fiber where the EX2200 switch sits. Any ideas??