Re: Router-on-a stick Cisco Router with Juniper Switch

Here is the transciever information for the ASR1 Gig0/0/5 to Juniper6 ge-0/0/30 link.

Juniper:

                       Fiber                    Xcvr vendor       Wave-    Xcvr
Port Cable type        type  Xcvr vendor        part number       length   Firmware
30   GIGE 1000SX       MM    AVAGO              AFBR-5715PZ-JU1   850 nm   0.0

ASR1:

IDPROM for transceiver GigabitEthernet0/0/5:
  Description                               = SFP or SFP+ optics (type 3)
  Transceiver Type:                         = GE SX (19)
  Product Identifier (PID)                  = GLC-SX-MMD          
  Vendor Revision                           = A   
  Serial Number (SN)                        = FNS18272505     
  Vendor Name                               = CISCO           
  Vendor OUI (IEEE company ID)              = 00.90.65 (36965)
  CLEI code                                 = WOTRB9VBAA
  Cisco part number                         = 10-2626-01
  Device State                              = Enabled.
  Date code (yy/mm/dd)                      = 14/07/03
  Connector type                            = LC.
  Encoding                                  = 8B10B
                                              NRZ
  Nominal bitrate                           = GE (1300 Mbits/s)
  Minimum bit rate as % of nominal bit rate = not specified
  Maximum bit rate as % of nominal bit rate = not specified

I am using a (teal) multi-mode fiber cable for both connections.