Re: Router-on-a stick Cisco Router with Juniper Switch

So, I got in today and noticed that the ASR2 link to to Juniper6 is now working, pings between ASR2's IP and Juniper6's IP is successful. I don't think that there is any difference in configuration here...

Here is the output EssentialRoot requested:

Interface: ge-0/0/30.0, Index: 91, State: up, Port mode: Trunk
Native vlan: VLAN999
Ether type for the interface: 0x8100
VLAN membership:
    VLAN999, 802.1Q Tag: 999, untagged, msti-id: 0, unblocked
    VLAN100, 802.1Q Tag: 100, tagged, msti-id: 0, unblocked
Number of MACs learned on IFL: 0

Spanning tree interface parameters for instance 0

Interface    Port ID    Designated      Designated         Port    State  Role
                         port ID        bridge ID          Cost
ge-0/0/30.0    128:543      128:543  32768.dc38e1a15c41     20000  FWD    DESG 

Both routers have lldp enabled, ASR1 shows no neighbors while ASR2 shows Juniper6 now that that link is working.

Ashvin0, I'm not exactly sure what you mean by "P2P IP Config". I have connected the router ports directly and the pings work then.

I'm going to compare outputs between the two routers so I can try and see why ASR2 is working now (at least partially based on lldp neighbor output).