I am planning to „streach” some VLANs using MACsec and then run VRRP “over” it – i.e.:
- have trunk port on every of the two switches configured with MACsec
- run VRRP for RVIs connected to those VLANs on every L3 switch (both would have RVI for every VLAN).
L2:
Switch –-- trunk port --- (MACsec) ---- trunk port -- Switch
L3:
L3 switch –-- RVI1 (IPv4) ---- (VRRP) --- RVI2 (IPv4) --- L3 switch
Should I expect any problems with this setup? I am asking mostly about this MACsec part, as this part is pretty new for me. Will it work with VRRP? Are there any other things to consider?
Regards,
Pawel Mazurkiewicz