Hi All,
Currently i'm use preprovisioned setup on EX3300 with ver 14.x. As per url https://kb.juniper.net/InfoCenter/index?page=content&id=KB13879&smlogin=true it said need to put no split-detection command if two member. But may i know the behaviour happen if i put that command at more than 2 VC member such 3 to 8 member.
I'm ask this question because i have face some outage when i remove member 3 (line card) then the member 0 (RE) and member 1 (Backup RE) change to line card. I also put no split detection even VC member more than 2.
Thanks and appreciate someone feedback