Good day everybody.
I have 2 sw ex4200 in virtual chassis/
I know about no-split-detection
But the point is:
When Master fails - Backup becames Master within 1-2 seconds.
But if I reboot new Master ( failed old Master is still down) - New Master became a line card.
If I starts each switch separatly - it becames a line card.
It's very strange I think. In real life if one of switch fail, I need 1-2 days or so to buy new and change it
BUT if in this time I have a trouble with a light for example - my one Master switch change role to line card. And it's very bad
I use GRES, non-stop-routing also. Configs synchronyzed. And when I look config at switch that became lineecard I can see string with
set virtual-chassis no-split-detection