Hi Spuluka,
Actually, I rebuild the EX2200VC by the steps as below:
1. Split EX2200 Virtual Chassis into two standalone switches and power on them
2. Factory default and zeroized the EX2200 Switches
3. Install the JTAC recommended version(Junos 12.3R12) for each EX2200 switch
4. Shutdown the backup node EX2200 and configure master node EX2200 first by preprovisioned and vc ports
[edit virtual-chassis]
user@switch# set preprovisioned
user@switch# set member 0 serial-number abc123 role routing-engine
user@switch# set member 1 serial-number def456 role routing-engine
user@switch# set no-split-detection
[edit]
user@switch# run request virtual-chassis vc-port set pic-slot 0 port 46
user@switch# run request virtual-chassis vc-port set pic-slot 0 port 47
5. Power on the backup switch and configure vc ports of 46 and 47
6. Cable the vc port
7. Virtual Chassis will be establish
After I rebuild the VC, I can see all interfaces include master and backup member by show interfaces terse command,
but the backup switch still not forward any data traffic.
For my testing, I use 2 PCs one is cabling on master switch and other is cabling on the backup switch then they ping with each other and failed.
Do you have any suggestions?
Regards,
Dylen