Quantcast
Channel: All Ethernet Switching posts
Viewing all articles
Browse latest Browse all 10307

Re: Juniper QFX5110 and Catalyst 3560 problem

$
0
0

Also this is output of show interfaces ge-0/0/26

 

Physical interface: ge-0/0/26, Enabled, Physical link is Down
  Interface index: 764, SNMP ifIndex: 799
  Link-level type: Ethernet, MTU: 1514, LAN-PHY mode, Speed: 1000mbps, BPDU Error: None, Loop Detect PDU Error: None, Ethernet-Switching Error: None, Source filtering: Disabled
  Ethernet-Switching Error: None, MAC-REWRITE Error: None, Loopback: Disabled, Flow control: Disabled, Auto-negotiation: Disabled, Remote fault: Online, Media type: Fiber,
  IEEE 802.3az Energy Efficient Ethernet: Disabled, Auto-MDIX: Enabled
  Device flags   : Present Running
  Interface flags: Hardware-Down SNMP-Traps Internal: 0x4000
  Link flags     : None
  CoS queues     : 12 supported, 12 maximum usable queues
  Current address: d0:07:ca:44:b8:dd, Hardware address: d0:07:ca:44:b8:dd
  Last flapped   : Never
    Input packets : 0
    Output packets: 0
  Active alarms  : None
  Active defects : None
  PCS statistics                      Seconds
    Bit errors                             0
    Errored blocks                         0
  Ethernet FEC statistics              Errors
    FEC Corrected Errors                    0
    FEC Uncorrected Errors                  0
    FEC Corrected Errors Rate               0
    FEC Uncorrected Errors Rate             0
  PRBS Statistics : Disabled
  Interface transmit statistics: Disabled

  Logical interface ge-0/0/26.0 (Index 586) (SNMP ifIndex 800)
    Flags: Device-Down SNMP-Traps 0x24024000 Encapsulation: Ethernet-Bridge
    Input packets : 0
    Output packets: 0
    Protocol eth-switch, MTU: 1514
      Flags: Trunk-Mode

Viewing all articles
Browse latest Browse all 10307

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>