I am currently in a spot where I am trying to figure out the configuration of an EX4300 for my network. I am not sure how to setup the firewall filters to permit the correct traffic to pass in/out of the management port to reach the end points. Each port can only carry one type of traffic (e.i. data, voice, etc.). Each Vlan will only be hosted on this switch and they have helpers on the network.
If anyone is able to provide guidance or configuration examples, that would be greatly appreciated.
(I'm not the greatest at asking technical quesitons yet, so my terminology may be a little off.)
NetID - 1.1.1.0/26
Next-hop - 1.1.1.2/30
Management Vlan v1 - 1.1.1.1/30
Data Vlan v2 - 1.1.1.5/28
Voice Vlan v3 - 1.1.1.21/29
Printer Vlan v4 - 1.1.1.29/29
Call Manager (Voice tftp) - 2.1.1.1 and 2.1.1.2
Voice DNS (helpers) - 1.1.2.1 and 1.1.2.2
Data/Printer DNS (helpers) - 1.1.2.5 and 1.1.2.6
NTP - 1.1.2.20 (primary) and 1.1.2.21 (secondary)
Need ability to ssh from any endpoint in the 1.1.1.5/28 range
example ports:
ge-0/0/0 will be the management port
ge-0/0/5 will be a data only port
ge-0/0/10 will be a voice only port
ge-0/0/15 will be a printer only port