Dear All
I had an issue about a month ago with a EX4300 Virtual Chassis which Juniper Support helped resolve (2 thumbs up to Juniper Support to get the issue fixed). During the support call the Engineer asked for a copy of the configuration (RSI). When they examined the configuration they noticed we had 14 IP address in one VRRP group and the maximum number should be 8 IP Address per VRRP Group. This was not the cause of the issue, but Juniper have advised I should split the IP Address down to more groups.
I have VRRP setup in a couple of different location and most of these location are not on the same layer2 network.
My Question is, if I have 2 different VRRP-groups setup, one at site A and one at site B and I use the same VRRP Group ID and I connected the 2 sites at layer2 with no security between the 2 sites will VRRP try and converge the VRRP groups at site A and site B into one large VRRP group? Is there a way to say which Virtual Chassis's are a part of the VRRP Group.
And what is the maximum number of VRRP-group's I can have, or should I say what is the upper limit of the VRRP-Group ID?
Richard