Hi guys,
I am new to Junos. Having trouble getting native vlan to work for WAPs. I also tested with a cisco 3560 with no luck. However config was working on old EX2200. I also used ELS translater confirmed all commands are there. Any one have ideas?
Cannot ping 10.1.51.254 to 10.1.51.200 but can ping 172.16.2.254 to 172.16.2.200
Test setup with EX4300 ge-0/0/10 <-> fa0/4 cisco 3560
EX4300
set interfaces ge-0/0/10 native-vlan-id 51
set interfaces ge-0/0/10 unit 0 family ethernet-switching interface-mode trunk
set interfaces ge-0/0/10 unit 0 family ethernet-switching vlan members 2-15
set interfaces ge-0/0/10 unit 0 family ethernet-switching vlan members 51
set interfaces irb unit 2 family inet address 172.16.2.254/24
...
set interfaces irb unit 51 family inet address 10.1.51.254/24
set vlans AREA51 vlan-id 51
set vlans AREA51 l3-interface irb.51
set vlans vlan2 vlan-id 2
set vlans vlan2 l3-interface irb.2
...
show ethernet-switching interface ge-0/0/10
Routing Instance Name : default-switch
Logical Interface flags (DL - disable learning, AD - packet action drop,
LH - MAC limit hit, DN - interface down,
SCTL - shutdown by Storm-control,
MMAS - Mac-move action shutdown, AS - Autostate-exclude enabled)
Logical Vlan TAG MAC STP Logical Tagging
interface members limit state interface flags
ge-0/0/10.0 65535 tagged
vlan3 3 65535 Forwarding tagged
....
AREA51 51 65535 Forwarding untagged
vlan2 2 65535 Forwarding tagged
Cisco 3560
interface FastEthernet0/4
switchport trunk encapsulation dot1q
switchport trunk native vlan 51
switchport trunk allowed vlan 2-15
switchport mode trunk
interface Vlan2
ip address 172.16.2.200 255.255.255.0
!
interface Vlan51
ip address 10.1.51.200 255.255.255.0
show interfaces switchport
Name: Fa0/4
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 51 (VLAN0051)
Administrative Native VLAN tagging: enabled
Voice VLAN: none
Administrative private-vlan host-association: none
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk associations: none
Administrative private-vlan trunk mappings: none
Operational private-vlan: none
Trunking VLANs Enabled: 2-15
Pruning VLANs Enabled: 2-1001
Capture Mode Disabled
Capture VLANs Allowed: ALL
Protected: false
Unknown unicast blocked: disabled
Unknown multicast blocked: disabled
Appliance trust: none
Thanks.