Dear Experts,
I am new to Juniper and switched from Cisco. Here is simple situation: i am in configuration mode and already have port ge-2/0/15 as ether switch and assigned to vlan 20 - I am trying to delete the config from port 20 and set up as:
set interfaces ge-2/0/15 unit 0 family ethernet-switching
set interfaces ge-2/0/15 unit 0 family ethernet-switching vlan members 20
set ethernet-switching-options voip interface ge-2/0/15.0 vlan 80
edit ethernet-switching-options
set voip interface ge-2/0/15.0 forwarding-class ezqos-voice-fc
But when I try to put line: set ethernet-switching-options voip interface ge-2/0/15.0 vlan 80
I get the syntax error. When I configure new port from scratch all commands are working fine. This case is regarding reconfiguring existing port assigned to vlan. What is best practice to reset port to factory defaults like in cisco word I could do that. Thank You so much Juniper Experts, - Adam