Thanks for the reply. On the EX2200 and SRX they are both using the default vlan1. Since the Cisco switch belongs to another company I believe he's got the the port in trunk mode and allowing all vlans to go through. He's using the Cisco switch as a pass through switch. The SRX is handing out the DHCP. When I connect directly into the SRX from the EX2200 it works but as soon asI go though the Cisco, because it has to conectert the media type, it doesn't. I talked to the vendor who owns the Cisco switch and he seems to think it's not the Cisco. He tell me that it's a basic config with trunk mode on and allowing all vlans to pass though. I was going to take the Cisco switch out and put in a Juniper EX2200 non-PoE to see if that is the case.
↧